MINI HEX V2 SPECS
|Motor to Motor||226mm|
|Main Plate Thickness||4mm|
|Warrantied Parts||Carbon Fiber Main Plates|
Carbon Fiber Arms
The new low-profile Mini Hex V2 has a lower Center of Gravity resulting in better flight characteristics and 9g lighter than its predecessor. It supports 13XX-18XX motors and 4″ props. This quad is recommended for advanced builders only, the low profile makes everything very tight and all wires have to be hard soldered to the FC.
The carbon fiber main plates and arms are covered by our lifetime warranty.
4MM Carbon Fiber Main Frame
1.5MM Carbon Fiber Rear Top Plate
1.5MM Carbon Fiber Front Top Plate
1.5MM Carbon Fiber V3 Cam Braces x2
2x rubber dimes, 2x M2 washers, 2x sunknuts, 2x alumi thumbscrew
4 x 16mm M3 metal bolts (for PDB and flight controller)
4 x 4mm standoff (in between PDB and flight controller)
4 x M3 nylon nuts (for flight controller)
4 x 30mm M3 alumi standoffs (for front top plate)
4 x 13mm M3 alumi standoffs (for rear top plate)
8 x 7mm M3 metal bolts (for both top plates)
8 x 10mm M3 metal bolts (for securing standoffs onto main frame)
4 x 35mm landing skids, 4 x 12mm M3 metal bolts
WHAT ELSE IS NEEDED?
Receiver [+ Transmitter of course!] LiPo(s) [+LiPo Charger] Lots and Lots and Lots of Props!
IF YOU WANT TO ADD FPV?
HS1177 Style Camera