NOTE: The CLF4S V1.2 does not work with:
- EMAX Bullet ESCs
- Kiss ESCs
- ZTW Polaris 25a ESCs
- LittleBee Zeus ESCs
If you use these components or have a "death roll" issue, adding a cap to each ESC may solve the problem.
Version 1.4 fixes this without having to add caps and can be found here.
Need hardware to mount this to your frame? Please take a look at this page.
- LiPo Input: 2-6S (5V-30V)
- Power rail: 3.3v,5v,9v,vbat
- 132A ( MAX display ) Current sensor with 160A PDB build in
- 6 layer 2oz Copper PCB
- Size: 36x36mm
- Mount Holes: 30.5 x 30.5 mm
- CPU - STM32F405RGT6 (F4 chip)
- Full SD Card socket
- Build in 5V BEC 2A
- Build-in User selectable 9v or 5v 2A Filtered BEC For camera and VTX
- Dedicated Camera setting control pads along with camera power signal pads
- Dedicated VTX connection with along with TX4 for easy connect and control VTX
- Build in Betaflight OSD
- 4 UARTS + USB (UART1 , UART3 ,UART4, UART6 ) (Pinout TX1, TX4,RX4, TX6,RX6 )
- 5V LED strip output
- 4 motors on each corner for a better layout.
- Support RX : Dedicated Sbus hardware inverted ,Satellite RX, Ibus,TBS Crossfire
- Dedicated hardware inverted connect to UART3 for smartport telemetry
- 4 in 1 esc socket with external current sensor input
- Support TP and Smartaudio VTX
- Buzzer pads for external buzzer
Electronics are not warrantied beyond being dead on arrival.
If for whatever reason you have no time to check the electronics within 7 days of receiving them, then no warranty or replacement will be granted.
So please only order this if you have time to check for proper functioning within 7 days of arrival.
Claims for defective parts emailed to us after this 7 days period is up will be denied.